How to set up” IP address” on Eurisko encoder?

How to set up” IP address” on Eurisko encoder?

Set up the IP address in  "Network” settings on the user interface. Then click on “Apply” and reboot the device

    • Related Articles

    • How to access Eurisko Live encoder?

      In the Network and sharing section of the Control Panel, of the computer set up the default IPv4 address. Then open any browser on the computer and 192.168.1.168 to open the configuration panel of the encoder.

    • How to make Eurisko encoder work on RTMP transmission?

      Make sure that the IP address in the Networking Sharing Center of the Control Panel on the computer and  IP address in the Network section of the configuration panel of the encoder match.

    • How to connect Eurisko live encoder?

      You can connect Eurisko live encoder directly to any computer directly via ethernet cable.

    • How to set up bitrate in Eurisko?

      To set up the output” Bitrate” on the user interface. Then click “Apply”.

    • Capturing an IP Stream

      Make sure to select the IP Capture plug-in: Press Device select Select one of the IP Capture plug-ins Click OK Press Setup and specify the host address and the port for receiving the stream. Click OK. If the incoming stream is MPEG2 Transport Stream, ...