Playback Control through GPI input

Playback Control through GPI input

GPI pulses input on the PC COM port(s) can be used for playback control:

Open Settings menu > Modules > Remote tab.

Select the GPI Input plug-in and enable it.

Press Configure to specify the COM port for receiving the GPI pulses and the command to be executed at receiving certain GPI pulse.

Click on the white sheet button to add each command to the list

Click OK to apply.


    • Related Articles

    • Playback Control through DTMF tones

      DTMF tones input on the PC audio card can be used for playback control: Open Settings menu > Modules > Remote tab. Select the DTMF Input plug-in and enable it. Press Configure to specify the audio device for receiving the DTMF tones and the command ...

    • Playback control

      You can push the playback control buttons to control the playout or use the provided short keys. The Return button is active only after a Jump operation. Use it to go back to the point in playback before the jump. Use the Cue button to pause the ...

    • Proper installation of PlayBox GPI Relay Card Driver

      In order to properly install the driver, first Driver Signature Enforcement would need to be disabled in Windows. This is done in the following steps: 0. In a cmd with admin privileges run the following command: bcdedit /set testsigning on 1. Open ...

    • Can I use live input streams in the playlist while streaming?

      Yes. To avoid streaming buffer underflows or overflows due to input/output rate discrepancies, you need to limit the duration of continuous live streams up to 2 hours.

    • Automated VTR control

      Open Settings menu > Modules >Remote tab. Select the VTR Control plug-in and enable it. Press Configure to specify the connection COM port and some VTR-specific settings. Click OK to apply. Right-click somewhere on the playlist and select Add/Insert ...